AFMG Network Forum

Christian · Member

Description:

Loading an .emp in Eyes/room mapping module, does not load calculation parameters.

Version #: 5.58.0.1665

Steps to Reproduce:

make a room mapping calculation with AURA.
make a loudspeaker combination and save it.
close the room mapping window.
reopen the room mapping windows from the ribbon.
File>Load EASE Mapping file.
Mapping>AURA>Calculation

Notes:

This makes it impossible to figure out what the calculation parameters where at the time of creation.
This leads to non reproducible results when sending the project to someone else.

Christian · Member

I did notice in the File Info tab when viewing a mapping I can see the parameters.

But there are also discrepancies in naming, e.g "scattering method: standard" in file, whilst in the calculation tab it's "diffuse rain" on/off(checkbox).

This does still not solve the reproduction problem when sending the project file for analysis by a third party.

Workaround is to also send the result files, but now we're talking about packing the project for sending.

If the idea is to make the .eprj file be a standalone file, it should also contain calculation parameters.

What I do in the meantime is just send the entire project folder I'm working in, using alot more bandwidth and space, including all files.

AFMG Frank Siegmann · Member

Hi Christian,

yes, the calculation parameters are shown on the Info tab.

We'll revise the displayed content for forthcomming EASE versions once more.

Because there can be specific parameters for each run, they are only stored in the mapping result files.

Thank you for your feedback.