| Non-Zero Surface Integral Problem |
 Posted: Tue May 10, 2022 6:21 am |
 |
|
|
| Dear Colleagues, good morning
I faced with the problem: during closing the room a problem "Non-Zero Surface Integral" appears and all the room parameters turn to zero or become negatie (volume, surface). Moreover, holes appear in the room that weren't present before and I cannot deal with them. Consequently, I cannot proceed with AURA Mapping and calculations (RT etc).
I would be very thankful if it is possible to help me with this issue. |
|
|
_________________
With respect,
Roksoliana Pankovska |
|
|
|
| Posted: Tue May 10, 2022 12:25 pm |
|
|
| Agustín Arias |
| Member |
|
| |
| Joined: 10 Apr 2013 |
| Posts: 54 |
| Location: Caseros, Buenos Aires, Argentina |
|
|
|
|
|
| Hi Roksoliana
Did you check that the faces are well oriented? White side to exterior and yellow side to interior |
|
|
_________________
Eng. Agustín Arias
Ottobre & Ottobre, Acoustical Consultants
Buenos Aires, Argentina
agustin.arias@outlook.com |
|
|
|
| Posted: Tue May 10, 2022 12:42 pm |
|
|
|
| Dear Agustin,
Yes, everything was checked and orientation of all faces was correct before the room was closed. There were also no holes. |
|
|
_________________
With respect,
Roksoliana Pankovska |
|
|
|
| Posted: Tue May 10, 2022 1:03 pm |
|
|
| Agustín Arias |
| Member |
|
| |
| Joined: 10 Apr 2013 |
| Posts: 54 |
| Location: Caseros, Buenos Aires, Argentina |
|
|
|
|
|
| Ok. If you want to send me your packed project I can check it for you. My email is below.
Regards |
|
|
_________________
Eng. Agustín Arias
Ottobre & Ottobre, Acoustical Consultants
Buenos Aires, Argentina
agustin.arias@outlook.com |
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
AFMG Network Forum
