AFMG Network Forum

luisgsf · Member

Hello everyone,

I usually do one acoustic panel on a wall and then duplicate then. But the duplicates don't get to be polygons in face as the program don't do the corresponding hole in the wall.

Can you add to your list (hopefully fairly high on it) that when you duplicate polygons in face they actually do the hole? maybe 2 ways of duplicating, or any other method you think of? I'm pretty sure I'm not the only one with the issue (unless there is a way to do it and I don't know it)

Regards,

GS

AFMG Silke Bögelein · Member

Hi Luis,

Could you please also submit a description of the issue through our contact form? You can use the following link:
https://www.afmg.eu/en/form/contact

I'm not entirely sure I understand the behavior you're describing. From your post, it's unclear whether:

- you want to duplicate a face without duplicating the previously inserted cut-out polygon, or
- you want to duplicate both the main polygon and its corresponding cut-out together.

Could you clarify which workflow you're referring to?

Thanks,

Silke