Posted: Wed Mar 18, 2015 3:15 pm |
|
|
griffgb |
Member |
|
|
Joined: 18 Mar 2015 |
Posts: 1 |
|
|
|
|
|
|
| I am using EASEJr 4.3 and I am trying to do some mapping on multiple floors but my Direct mapping is still showing SPL on the floor that should be shadow cast from the floor above. The floor above (face) has the shadow cast box checked. I have also selected that face as a 2-fold face since it is the second floor in the venue with seats.
Any help would be appreciated. |
|
| _________________ Gary Griffith |
|
|
|
Posted: Wed Mar 18, 2015 4:31 pm |
|
|
Jim Mobley |
Member |
|
|
Joined: 27 Jul 2005 |
Posts: 134 |
Location: Foothill Ranch, California, USA |
|
|
|
|
|
| Hi Gary,
The Shadow Cast check mark in the Face Properties is informational, unless you click it off and choose locked, in which case the face will never cast a shadow. You can use this function if you want to draw in transondant materials like scrims or perforated screens.
To map with shadow cast you must check Shadow Cast on the fourth (Calculation) tab of the Calculation Parameters dialog when you setup the mapping.
Shadow Cast is not enabled by default as it increases calculation time, sometimes significantly, and is not necessary in many calculations.
[/img] |
|
| _________________ Best regards,
Jim Mobley
Sr. Application Engineer
Renkus-Heinz, Inc.
19201 Cook St.
Foothill Ranch, CA 92610 USA
TEL: +1-949-588-9997
FAX: +1-949-588-9514
www.renkus-heinz.com
mailto:jim@renkus-heinz.com |
|
|
|
AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|