AFMG Network Forum
AFMG Network Forum Index -> AFMG SysTune -> Systune and mic calibration
Post new topic  Reply to topic View previous topic :: View next topic 
Systune and mic calibration
PostPosted: Sun Dec 09, 2012 10:58 pm Reply with quote
Cillol
Member
 
Joined: 31 Jan 2010
Posts: 3




Hi,
I often use Systune with a Motu Ultralite MKII and a M30 mic calibrated for SPL reading. If I launch Systune without the Motu connected or with another soundcard, I loose the calibration and the next time that I come back to the Ultralite and the M30, I need to do the calibration procedure again.
Would be very useful if Systune can have a chance to store the calibration data somewhere, since that I have a soundcard with digitally controlled preamp.
Thank you
luca
View user's profile Send private message
PostPosted: Mon Dec 10, 2012 10:56 am Reply with quote
Bruce
Member
 
Joined: 19 Apr 2005
Posts: 459
Location: Minneapolis, MN, USA




Luca,

Once you have calibrated the system, then use File | Save Setup File to save a setup file. This will include all calibrations done with this hardware. I have different ones save for each audio device I use. Then use File | Open Setup File once you are connected to load the saved settings.

_________________
Best Regards,
Bruce C. Olson
View user's profile Send private message Send e-mail Visit poster's website
PostPosted: Fri Dec 21, 2012 9:32 pm Reply with quote
Gert Sanner
Member
 
Joined: 08 Dec 2011
Posts: 11
Location: Birmingham UK




I would like to second that. Should you use the Motu Software you can also save the Gainsettings for calibration. So once you have set up and calibrated save one File in Systune and one in Motu and you can always go back in a mouse click.
I have tested this over 12 month and it goes back to the exact values.
View user's profile Send private message Visit poster's website
PostPosted: Mon Dec 24, 2012 10:00 am Reply with quote
Bruce
Member
 
Joined: 19 Apr 2005
Posts: 459
Location: Minneapolis, MN, USA




Gert Sanner wrote:
I would like to second that. Should you use the Motu Software you can also save the Gainsettings for calibration. So once you have set up and calibrated save one File in Systune and one in Motu and you can always go back in a mouse click.
I have tested this over 12 month and it goes back to the exact values.


And of course I should also mention that this is also true for the Aubion X.8. Normally they are also automatically saved as well, but sometimes I am using my mics with hard-wired connections, and other times with the RF TX/RX, and so I have a few setups saved there also depending on which mic kit is being used.

_________________
Best Regards,
Bruce C. Olson
View user's profile Send private message Send e-mail Visit poster's website
AFMG Network Forum Index -> AFMG SysTune
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT  
Page 1 of 1  

  
  
 Post new topic  Reply to topic  


Powered by phpBB © 2001-2003 phpBB Group
Theme created by Vjacheslav Trushkin
Variation by CodeWeavers and AFMG