|
|
| I have been having an error at startup of EASE that showed up about a half year ago. "ERROR IN SLSE_SaveBytesToLog" Code 9:Subscript out of range. The program appears to work fine after I ... |
|
|
|
|
| In live mode, i wish to save the spectrum for later analysis. I pause the measurement and ctrl-a. the program responds with "no data to save". I have tried it with the measurement running an ... |
|
|
|
|
thank you Bruce
Is there a specific window function that is used?
I was trying to chop off the data without a function but I was unclear on windowing without processing |
|
|
|
|
EASERA users
I have managed the procedure to find the "reflection factor" in dB via the procedure in the EASERA manual.
My difficulty is in converting this to a absorption coefficient-
... |
|
|
|
|
I am experiencing an error at EASE startup:
Heading:
"Error in SLSE_Save Bytes Too Long"
Detail:
"Code 9 Subscript out of Range"
After I OK the error message, EASE starts up ... |
|
|
|
|
Bruce gave me the down-lo:
1) extruding the segment will have to do.
2) any set of faces can be grouped as an object and then properties assigned in a blanket fashion. the object does not need to ... |
|
|
|
|
I had three questions:
1) on an imported curved wall I have 250 surfaces, and I wish to make them layered on the top 1/2 with a new material. Any shortcuts other than to extrude the line segment at t ... |
|
|
| Page 1 of 1 |
All times are GMT |
|
AFMG Network Forum
Forum: