AFMG Network
Forums for AFMG Software
AFMG Network Forum Index -> EASE - Discussion -> column modeling
Post new topic  Reply to topic View previous topic :: View next topic 
column modeling
PostPosted: Fri Jan 26, 2018 9:02 am Reply with quote
Lavzvuk
Member
 
Joined: 01 Feb 2016
Posts: 2




Dear colleagues, I ask you to explain how to simulate the columns in a room in a vaccine so that the ease can make a correct calculation.
View user's profile Send private message
PostPosted: Fri Jan 26, 2018 1:59 pm Reply with quote
Waldemar
Member
 
Joined: 05 Dec 2005
Posts: 105




A column is a closed cylinder. The EASE front material has to be to the outside of the column. If the bottom face is at the floor, it has to be a coat of the floor face. The same is valid for the ceiling face.

_________________
Best Regards
SDA, Waldemar Richert
View user's profile Send private message
PostPosted: Mon Jan 29, 2018 9:11 am Reply with quote
Lavzvuk
Member
 
Joined: 01 Feb 2016
Posts: 2




the area under the column will not participate in the calculation?
View user's profile Send private message
PostPosted: Wed Jan 31, 2018 5:19 pm Reply with quote
Bruce
Member
 
Joined: 19 Apr 2005
Posts: 430
Location: Minneapolis, MN, USA




Lavzvuk wrote:
the area under the column will not participate in the calculation?


It will not if it is a coat of the floor.

_________________
Best Regards,
Bruce C. Olson
View user's profile Send private message Send e-mail Visit poster's website
column modeling
AFMG Network Forum Index -> EASE - Discussion
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT  
Page 1 of 1  

  
  
 Post new topic  Reply to topic  


Powered by phpBB © 2001-2003 phpBB Group
Theme created by Vjacheslav Trushkin
Variation by CodeWeavers