AFMG Network Forum
AFMG Network Forum Index -> AFMG EASERA -> wireless measure
Post new topic  Reply to topic View previous topic :: View next topic 
wireless measure
PostPosted: Tue Sep 04, 2007 2:47 pm Reply with quote
rrodolphe
Member
 
Joined: 30 Aug 2007
Posts: 35
Location: france




hello I have buy et receive a wireless transmiter tm400 . I have try to make some measure to test it.
The configuration is a pc laptop, a interface AXYS, a bruel et kjaer microphone with a geffen preanmplier 48v
I make a measure direct microphone in my interface and microphone with wireless transmitter
the reponce is very diferent (see the document joint) Bleu with transmitter, Red without transmitter
can you help me?
thank you
rodolphe
sorry but i can put my picture
[img]C:\Documents and Settings\rroellinger\Bureau\courbe.PNGimg[/img]
View user's profile Send private message
PostPosted: Tue Sep 11, 2007 6:57 pm Reply with quote
Stefan
Member
 
Joined: 19 Apr 2005
Posts: 167
Location: Berlin, Germany




Email response by Jim Mobley

Quote:
Dear Rodolphe,

Your attachment was stripped off by the Forum, can you send it to me directly?

Your setup should work fine, the TM400 is an excellent product--we use one frequently. I can offer some general trouble shooting tips.

1) Be sure that nothing is clipping and that you have a good signal to the input of the sound card.
2) We've seen some problems with the TM400 transmitter being unable to supply enough phantom power for some measurement mics. In some cases this can be resolved by inverting the polarity with an adaptor between the mic and the transmitter.
3) Test the RF section as a piece of wire by driving the transmitter directly from the sound card. Be sure to SWITCH OFF PHANTOM POWER AT THE TRANSMITER TO AVOID DAMAGING THE OUTPUTS OF THE SOUND CARD.

If you can send the measurements instead of the screen shot, that would be better.

Best regards,

Jim Mobley
Sr. Application Engineer
Renkus-Heinz, Inc.
19201 Cook St.
Foothill Ranch, CA 92610
TEL: +1-949-588-9997
FAX: +1-949-588-9514
www.renkus-heinz.com
mailto:jim@renkus-heinz.com


Stefan
View user's profile Send private message Send e-mail Visit poster's website
PostPosted: Wed Sep 12, 2007 8:48 am Reply with quote
rrodolphe
Member
 
Joined: 30 Aug 2007
Posts: 35
Location: france




thank you for the responce, the first and third point are good.
I have found the problem, the second point with microtech gefell preamplifier the signel must be reverse with an adaptator.
i dont understand the problem of polarity .
but all is well
roodlphe
View user's profile Send private message
AFMG Network Forum Index -> AFMG EASERA
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT  
Page 1 of 1  

  
  
 Post new topic  Reply to topic  


Powered by phpBB © 2001-2003 phpBB Group
Theme created by Vjacheslav Trushkin
Variation by CodeWeavers and AFMG