AFMG Network Forum

AFMG Network Forum Index Search found 7 matches Ray Tracing Forum: EASE 4   Posted: Mon Aug 29, 2005 7:21 pm   Subject: Ray Tracing dblount   Replies: 4 Views: 13098 Jim, Thanks for the reply. If only it were that simple. My faces are varied, none of which are absorbers. Any other ideas? Thanks, Denis. Ray Tracing Forum: EASE 4   Posted: Mon Aug 29, 2005 2:59 pm   Subject: Ray Tracing dblount   Replies: 4 Views: 13098 Hello, In ray tracing, despite have an order of 3, i don't see a bounce off faces. The ray terminates at the first face it hits. My settings are: Order: 3 Time: 1000ms Loss: 60 dB Directed ... Strange roll-off in reverb time below 250Hz? Forum: EASE 4   Posted: Fri Jul 08, 2005 7:48 pm   Subject: Strange roll-off in reverb time below 250Hz? dblount   Replies: 2 Views: 10908 Hello again, I've finally got this project where i need it, thanks to everyones help. after looking over the drawing with our principle, the steep roll-off in reverb time below 250 seems stran ... No Floor? ("Error occured in Draw Room") Forum: EASE 4   Posted: Wed Jul 06, 2005 4:46 pm   Subject: No Floor? ("Error occured in Draw Room") dblount   Replies: 1 Views: 8620 ADMIN: This is a Follow-Up to topic "Negative Reverb time" Hello, i have finally removed all holes from this project. but to get to this point, it seems i had to remove the floor face. when i ... Negative Reverb time Forum: EASE 4   Posted: Tue Jul 05, 2005 1:00 pm   Subject: thanks... dblount   Replies: 4 Views: 13301 Negative Reverb time Forum: EASE 4   Posted: Wed Jun 29, 2005 3:11 pm   Subject: Negative Reverb time dblount   Replies: 4 Views: 13301 Bruce, Thanks for the reply. Now i keep getting an error that is reported in the log as follows: Error occured in Draw Room: 11:10:34 AM Error during execution of ITEM_Invisible_ID: ITEM_Kin ... Negative Reverb time Forum: EASE 4   Posted: Tue Jun 28, 2005 4:22 pm   Subject: Negative Reverb time dblount   Replies: 4 Views: 13301 I have a problem with EASE 4.1.0.7. I have just imported a hall from a dxf, checked the data, closed the holes, and now the room data say I have a negative volume, and the RT is wrong…most of the oct ... Page 1 of 1 All times are GMT Select a forum General----------------Board RulesForum Announcements Software Forums----------------EASE 5EASE 4EASE EvacAFMG EASERAAFMG SysTuneAFMG SoundFlowAFMG ReflexEASE FocusEASE AddressSDK for GLL PLug-in API   Powered by phpBB © 2001-2003 phpBB Group Theme created by Vjacheslav Trushkin Variation by CodeWeavers and AFMG