AFMG Network Forum

Jack · Replies: 4

OK it's clear for me now and will apply the window during the measurements too.
Now I will get some measurements And notice you if anything goes wrong with
the procedures.
Thanks very much Charlie ...

Jack · Replies: 4

Yes, this helps me and I will proceed as you explain but it remains
a question about when I will save the automated measurement,
If I use dual channel FFT,can I save the windowed impulse as
if I m ...

Jack · Replies: 0

excuse me I made a mistake in my preceding question.
the reflexion is at 30ms after the 0 time not 20ms
and replace the 18ms and 19ms by 28 and 29ms for
the windowed time.
Sorry.

Jack · Replies: 4

I want to measure automated polar response of loudspeaker
for exporting in speakerlab and would like to know the method
for windowing impulse response without loosing phase data
and without cutting ...

Jack · Replies: 2

You understand correctly Charlie ,I will measure at 10 feet high so
the ceiling is at 20 feets and the walls more than 40 feets apart
so I will measure with a window maybe a little less thans 10 ms ...

Jack · Replies: 2

HI,I would like to measure polar data in a Gymnasium with long
reverb time (maybe 1 or 2 seconds I didn't measure yet) and would like
to know if this long reverb time will pollute my measurement and ...

Jack · Replies: 8

thanks stefan it's clear for me now,I must have easera pro for the job.

Jack · Replies: 8

Thanks Stefan for your rapid reply to my post;
I have one more question about this topic; in easera manual it's mentioned that the editing sequence is only for representation and that the original da ...

Jack · Replies: 8

HI,I wouls like to know the best procedure for taking balloon data with easera;currently I don't have easera pro,just easera;but if necessary I will upgrade to easera pro.With my current version of ea ...